12 Gauge Rock & Lock Shotgun Magazine Carrier
Every 12 Gauge Rock & Lock Shotgun Magazine Carrier will include x4 Male mounting screws, x4 Female Mounting Screws, x4 Rubber Mounting Spacers and either X2 Malice Clips for Molle mounting or X1 DCL Combat Loop for Belt mounting.
To remove or adjust the mount included with the carrier, simply open the mount, place one finger inside the carrier on the back of one of the female mounting screws and with a Phillips head screwdriver undo the male screw on the outside face of the carrier. If you are unable to apply enough pressure to the back of the female mounting screw inside the carrier, try putting a wide rubber band between your finger and the female mounting screw you’re trying to undo. All magazine carriers have the ability to be mounted either way around by swapping the side the mounting system is attached on.
The magazine carriers also come with adjustable retention for the ability to tighten or loosen the grip the carrier has on your magazines. This can be achieved by tightening or loosening the screws on the wing of the magazine carrier until you reach your desired amount of retention. Please note that the magazine can only be inserted into the Magazine carrier in one orientation.
Features:
-
Made from 2mm P1 Kydex T Thermoplastic
-
Wrapped in IR Compliant Genuine 500D Cordura (where applicable)
-
All Mounting screws will have threadlock pre-applied to stop them from backing out or coming loose over time
-
Adjustable Retention
-
Left or right side mounting
-
Fits onto molle or up to 2” wide belts
If during use, you have any issues with the function of the Magazine Carrier, do not hesitate to contact us through the form on this website or email us at Sales@kydexcustomsuk.com